MIL-D-21523A(Wep)
Special Test Equipment - The following items
4.4
of test equipment are required to perform the acceptance
tests set-forth in this specification:
Shock Test Fixture
SA-2440495
Bilateral Test Fixture
SA-2586826
SA-2586865
Bilateral Test Control Panel
Submersion Fixture
SA-2586881
Production Tests
4.5
Responsibility - The contractor or Government
4.5.1
Inspector shall conduct production tests as specified in
paragraph 4.3.1 to assure that the diaphragm assembly is
in compliance with the requirements of 3.3.1 and 3.3.2.
Test Conditions - Unless otherwise specified,
4.5.2
the diaphragm assembly shall be subjected to production
tests under the following conditions:
-
Room ambient, +65 to +85
Temperature :
degrees Fahrenheit
Normal, ground atmospheric
Altitude:
pressure
None
Vibration:
Relative humidity of 50 percent
Humidity:
or less at +78 degrees Fahrenheit
Test and Inspection Equipment and Facilities -
4.5.3
The manufacturer shall furnish and maintain all necessary
test equipments facilities, and personnel for performing
all production tests. The test equipment shall be adequate
in quantity and, unless definite requirements are specified
shall be of sufficient accuracy and quality to permit per-
formance of the required production tests.
Calibration - Measuring equipment and instru-
4.5.3.1
mentation shall be calibrated as required by NAVORD INST
4355.1, BUWEPS INST 4355.5, and in accordance with the
policies specified in the Standards Laboratory Information
Manual issued by Bureau of Naval Weapons Representatives
Pomona, California.
-11-
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business