MIL-F-21527B(Wep)
Materials - Unless otherwise specified in the con-
3.2.2
tract, requisition, or order, all materials and purchased
parts entering into the final assembly of the air flask
shall conform strictly to the detailed requirements indi-
cated on the drawings and specifications listed in BuWep
Dwg 2023561 and 2024826 or 2024898 and 2024899.
Finishes, Coatings, Construction, and Dimensions -
3.2.3
Finishes, coatings, construction, and dimensions for the
air flask shall be in accordance with the applicable draw-
ings, specifications, and publications listed in BuWep
Dwg 2023561 and 2024826 or 2024898 and 2024899.
Marking - Marking of the air flask shall be done
3.2.4
by stamping in accordance with BuWep Dwg 2023561 and
20248260F 2024898 and 2024899.
Interchangeability - Individual piece parts of the
3.2.5
air flasks fabricated in agreement with the applicable
drawings and specifications, shall be interchangeable with
like numbered parts.
Gages - The contractor shall provide himself with
3.2.6
whatever gages are necessary and adequate to insure that
the material to which this specification applies will meet
the dimensional requirements shown on the applicable draw-
ings. If so stipulated in the contract, requisition, or
order, the Government will furnish drawings of pertinent
Navy Final Inspection Gages for guidance in the design of
the contractor's inspection gages. However, such proce-
dure shall not serve to relieve the contractor of' his
responsibility in the design and manufacture of such gages
as may be required for the satisfactory fulfillment or the
contract requirements but is intended to facilitate
acceptance of all components and assemblies by Navy Final
Inspection Gages.
Threads - Unless otherwise specified, all threads
3.2.7
shall be in accordance with the National Bureau of
standards Handbook H28. The class or fit for threads
shall be as specified on the applicable drawings.
3.2.8 Request for Deviations - The procedures for re-
questing deviations from this specification or any speci-
fication, publication, material, or process specified
herein shall be as set forth in OP 400.
-5-
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business